Installation Instructions

STEP 1:

Covers arrive without a cutout for the conduit box or lifting lugs (if any). Align the back end of the cover so it extends about 1" past the drive end of the motor. Fig 1. (Be sure to clean the motor cooling fin channels and air intake before installing the cover).

STEP 2:

With a black pen, mark the location of the conduit box cutout. Fig 2.

STEP 3:

Using a jig saw or similar type saw, cut out the conduit box slot in the side of the cover. Fig 3.

STEP 4:

Stretch the sides of the cover and snap over the motor. The angled end of the cover should extend out and over the air intake. Fig 4.